05/04/04

So the paint is dry so heres the latest photo's

The paint as dried a Matt finish and looks good, any white areas are just the flash off the camera, some photos the colour doesn't look correct but it is!!! the photo below with the seats looks about right to the eye.

Fitted seats

Fitted wheel arches

Fitted rear grill cover

Fitted back seats

William just couldnt wait to get in it after i had collected him from Nursery (made him wipe his feet first)

Spent alot time time trying to sort out the new petrol pipe which ended up leaking due to wrong fittings!! also lost time messing with the lever arm suspension bushes! best way I've found to do this is to put a small leading edge on the rubber bush, take out the steel center bush, fit rubber into lever arm and off set bolt (very tight but add a bit of grease) then push the steel bush in as far as you can (wont go in far) then put a longer bolt through with two bigger washers either end, fit a nut and use the nut to pull the steel bush into the rubber bush as you tighten the bolt and nut up.